DLT-V4 Product Manual
Fault
Clean
–
Key
Off
–
On
Blinking–slow (approximately once per second)
Blinking–medium (approximately twice per
second)
Blinking–fast (approximately three times per
second)
Indicates that the status of this LED does not
depend on the specific tape drive condition. This
means that certain tape drive conditions may result
in a combination of two or more of the LED states
in the chart.
For example, if you need to clean the tape drive
while a DLT1 tape is loaded, both the
and
write/read diagnostic fails due to a permanent
write error, both the
blink slowly.
Chapter 4 Using Your Tape Drive
Media
Description
Cleaning required—250 tape motion
hours exceeded since last cleaning
Cleaning in process
–
User invoked write/read diagnostic
failed
Servo or mechanical error
Internal firmware error
–
LED are on steadily. If an internal
Media
Fault
LED Indicators
LED
Clean
LED and
LED
Clean
49