Tandberg Data DLT-V4 Product Manual page 34

DLT-V4 Product Manual
Obtain a SCSI cable with an open 68-pin, high-density connector.
6
Connect one end of the SCSI cable to the SCSI connector on the rear
7
panel of the tape drive. The SCSI connectors are keyed, preventing
improper connection.
If the SCSI cable does not fit the connector on the SCSI
Note:
host adapter, you either have an incompatible SCSI host
adapter or you need to purchase a cable adapter. Contact
your sales representative or the SCSI host adapter
manufacturer for information. See
Internal SCSI Tape Drive
need to use an LVD/SE terminator with the SCSI cable.
Connect the other end of the SCSI cable to the SCSI host adapter,
8
aligning the colored stripe on the cable with pin 1 on the SCSI host
adapter's connector.
Locate an available power cable in the server or workstation and
9
attach it to the power connector on the rear panel of the tape drive.
The connector is keyed, preventing improper connection.
Chapter 2 Installing the Tape Drive
Installing the Internal SCSI Tape Drive
Terminating the
on page 17 to determine if you
22