Options; Cycle Signal - Kenmore 7703 - Elite Oasis 7.0 cu. Ft. Capacity Flat Back Gas Dryer Use And Care Manual

Timed Cycle Modifiers
Use the Temperature Modifier to select temperatures for the
Timed Cycles. Press Temperature until the desired temperature
setting illuminates.
NOTE: Temperature modifiers cannot be used with the Auto Dry
Cycles.
High
Medim
Low
ExtlaLow
Air lily
Temperature
yoJusfs lIMED Cy(,#5
oNiY
Air Dry
Use the Air Dry Modifier for items that require drying without heat
such as rubber, plastic and heat-sensitive fabrics. This table
shows examples of items that can be dried using Air Dry.
Type of Load Time*
(Minutes)
Foam rubber - pillows, padded bras, stuffed toys 20 - 30
Plastic - Shower curtains, tablecloths 20 - 30
Rubber-backed rugs 40 - 50
Olefin, polypropylene, sheer nylon 10 - 20
*Reset cycle to complete drying, if needed.
When using Air Dry
• Check that coverings are securely stitched.
• Shake and fluff pillows by hand periodically during the cycle.
• Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Air Dry is not available with Auto Dry Cycles.
You can customize your cycles by selecting options.
OPTIONS
Q Damp Dry Signal
AUlOC_CL SOL¥
Wrinkle Guard 60
Damp Dry Signal
Select the Damp Dry Signal to alert you that your clothes are
approximately 80% dry or suitable for ironing. This is useful when
you want to remove lightweight items in a mixed load to avoid
overdrying or remove partially dry items that may need ironing.
The DAMP DRY SIGNAL is usdul when drying bedsheets/linens
in a mixed load. When the signal goes off, open the door to stop
the dryer, rearrange the load inside the dryer, close the door and
restart the dryer to finish the drying cycle. Rearranging the load
will aid in the drying process.
NOTE: The Damp Dry Signal is available only with the Auto Dry
Cycles.
WRINKLE GUARD _ (30, 60, 90, 150 minutes)
WRINKLE GUARD ®helps smooth out wrinkles that may form
when clothes are not removed promptly at the end of a cycle.
During this option, the dryer stops tumbling and then tumbles
again for a brief period without heat when WRINKLE GUARD®is
pressed.
• Press WRINKLE GUARD ®to get heat-free, periodic tumbling
at the end of a cycle. WRINKLE GUARD ® periodically starts
and stops the dryer, tumbling the load without heat for 30, 60,
90 or 150 minutes (depending on your model) unless you
open the dryer door.
• Stop WRINKLE GUARD ® at any time by pressing WRINKLE
GUARD ®, opening the dryer door or pressing STOR
• For the Casual Cycle, WRINKLE GUARD ® is preset to ON.
The other Auto Dry Cycles will retain the WRINKLE GUARD ®
setting. For example, if you select WRINKLE GUARD ® in the
Normal cycle, WRINKLE GUARD ®will be on the next time you
select the Normal cycle.
NOTE: If you do not select WRINKLE GUARD ® , the dryer stops
after cool down.
Cycle Signal
The Cycle Signal produces an audible sound when the drying
cycle is finished. Promptly removing clothes at the end of the
cycle reduces wrinkling.
Press CYCLE SIGNAL to turn the Cycle Signal On or Off.
On
Off
Cycle Signal
NOTE: When WRINKLE GUARD _ is selected, a tone sounds
every 5 minutes until the clothes are removed, or WRINKLE
GUARD ® ends.
You can change Auto and Timed Cycles, Modifiers and Options
anytime before pressing Start.
• Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
Changing Cycles after pressing Start
1. Press STOP twice.
18