Download  Print this page

Installation Instructions - Kenmore 7703 - Elite Oasis 7.0 cu. Ft. Capacity Flat Back Gas Dryer Use And Care Manual

Use and care guide
Hide thumbs


Table of Contents
_N G:
To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions,
including the following:
Read all instructions
before using the dryer.
Do not place items exposed to cooking
oils in your dryer.
Items contaminated
with cooking
oils may contribute
a chemical
reaction that could cause a load to catch fire.
Do not dry articles that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline, dry-
cleaning solvents, or other flammable or explosive
as they give off vapors that could ignite or
Do not allow children to play on or in the dryer. Close
of children is necessary when the dryer is
used near children.
Before the dryer is removed from service or discarded,
remove the door to the drying compartment.
Do not reach into the dryer if the drum is moving.
Do not install or store the dryer where it will be exposed
to the weather.
Do not tamper with controls.
Do not repair or replace any part of the dryer or attempt
any servicing unless specifically recommended
in this
Use and Care Guide or in published user-repair
that you understand and have the skills to
carry out.
Do not use fabric softeners or products to eliminate static
unless recommended
by the manufacturer of the fabric
softener or product.
Do not use heat to dry articles containing foam rubber or
similarly textured rubber-like materials.
Clean lint screen before or after each load.
Keep area around the exhaust opening and adjacent
areas free from the accumulation
of lint, dust,
and dirt.
The interior of the dryer and exhaust vent should be
cleaned periodically
by qualified service personnel.
See installation instructions
for grounding requirements.
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70.
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
8" or 10" pipe wrench
8" or 10" adjustable
wrench (for gas
Flat-blade screwdriver
Adjustable wrench that
opens to 1" (2.54 cm) or
hex-head socket wrench
(for adjusting dryer feet)
Vent clamps
Pipe-joint compound
resistant to LP gas
Caulking gun and
(for installing
new exhaust vent)
Tape measure
Parts supplied
Remove parts package from dryer drum. Check that all parts
were included.
4 Leveling legs
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read "Electrical
"Gas Supply Requirements" and "Venting
before purchasing parts.
Mobile home installations require special parts (listed following)
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
Mobile Home Installation Kit. Ask for Part Number 346764.
Metal exhaust system hardware.



Table of Contents

  Related Manuals for Kenmore 7703 - Elite Oasis 7.0 cu. Ft. Capacity Flat Back Gas Dryer

This manual is also suitable for:

Oasis 110.7703 seriesOasis 110.7704 series