Table of Contents
Advertisement
Adjusting of the minimum
of the top burners
In the minimum position the flame must
have a length of about 4 mm and must
remain lit even with a quick turn from the
maximum position to that of minimum.
The flame adjustment is done in the follow-
ing way:
Semi-rapid and triple ring burners
– Light the burner
– Set the gas valve to
– Remove the knob
– With a thin screwdriver pass by the hole of
microswitch and turn the screw F until
adjustment is correct (fig. 61).
Inside crown of DUAL burner
– Light the DUAL burner
– Set the gas valve to
– Remove the knob
– Using a screwdriver turn the screw H until
the correct setting is obtained (fig. 62).
Outside crowns of DUAL burner
– Light the DUAL burner
– Set the gas valve to
– Remove the knob
– Using a screwdriver turn the screw G until
the correct setting is obtained (fig. 62).
Normally for LPG, tighten up the regu-
lation screw.
58
position
position
position
Fig. 61
G
Fig. 62
F
H
Advertisement
Table of Contents
