CDA RV 1200 Series Installation Instructions Manual page 56

Gas connection
The gas supply must be connected to the gas inlet which is located at the rear of the
appliance (see figure 56).
If the connection pipe cross the cooker, it must be positioned under the cooker rear
protection.
To screw the connecting tube operate with two spanners (fig. 57).
After connecting to the mains, check that the coupling are correctly sealed,
using soapy solution, but never a flame.
Cooker
cooker
rear protection
rear protection
Gas pipe
gas pipe
56
GB
Cat: II 2H3+
1/2" BSP (male)
Fig. 56
Fig. 57