Table of Contents
Advertisement
Lighting gas burner fit-
ted with flame failure
safety device
(Dual Burner)
In order to light the burner, you must:
1 – Push and turn the knob in an anti-
clockwise (fig. 5) direction up to the
position (maximum rate of inner
and outer crowns); push in and hold
the knob until the flame has been lit.
The sparks produced by the lighter sit-
uated inside the relative burner will
light the flame.
In the event that the local gas supply
conditions makes it difficult to light
the burner in
with the knob in
If there is no mains electrical supply
connection, bring a lighted match
close to the burner.
2 – Wait for about ten seconds after the
gas burner has been lit before letting
go the knob (safety device activation
delay).
3 – Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
the closed position (
least 1 minute and then repeat the
lighting procedure.
Note: To change from using the inner
crown only to using both the inner and
outer crowns together, press the control
knob down before turning it. You have to
do the same when going from using
both crowns to using just the inner
crown.
position, try again
position.
), wait for at
Fig. 5
N.B. When the cooker is not being
used, set the gas knobs to their
positions and also close the gas shut-
off valve placed on the main gas sup-
ply line.
Caution!
The cooker becomes very hot
during operation.
Keep children well out of
reach.
13
Advertisement
Table of Contents
