Variable Speed Fan; Boxed Processor Fan Heatsink Set Points; Fan Heatsink Power And Signal Specifications - Intel I7-900 DESKTOP PROCESSOR - DATASHEET VOLUME 1 Datasheet

Table of Contents

Advertisement

Boxed Processor Specifications
8.4.2

Variable Speed Fan

If the boxed processor fan heatsink 4-pin connector is connected to a 3-pin
motherboard header it will operate as follows:
The boxed processor fan will operate at different speeds over a short range of
internal chassis temperatures. This allows the processor fan to operate at a lower
speed and noise level, while internal chassis temperatures are low. If internal
chassis temperature increases beyond a lower set point, the fan speed will rise
linearly with the internal temperature until the higher set point is reached. At that
point, the fan speed is at its maximum. As fan speed increases, so does fan noise
levels. Systems should be designed to provide adequate air around the boxed
processor fan heatsink that remains cooler then lower set point. These set points,
represented in
heatsink to fan heatsink. The internal chassis temperature should be kept below
40 ºC. Meeting the processor temperature specification (see
responsibility of the system integrator.
The motherboard must supply a constant +12 V to the processor's power header to
ensure proper operation of the variable speed fan for the boxed processor. Refer to
Table 8-1
Figure 8-9.

Boxed Processor Fan Heatsink Set Points

Table 8-2.

Fan Heatsink Power and Signal Specifications

Boxed Processor Fan
Heatsink Set Point
(
X  30
Z  40
Notes:
1. Set point variance is approximately ± 1 C from fan heatsink to fan heatsink.
Datasheet
Figure 8-9
and
for the specific requirements.
Lowest Noise Level
X
Internal Chassis Temperature (Degrees C)
°
C)
When the internal chassis temperature is below or equal to this set point,
the fan operates at its lowest speed. Recommended maximum internal
chassis temperature for nominal operating environment.
When the internal chassis temperature is above or equal to this set point,
the fan operates at its highest speed. Recommended maximum internal
chassis temperature for worst-case operating environment.
Table
8-2, can vary by a few degrees from fan
Increasing Fan
Speed & Noise
Boxed Processor Fan Speed
Chapter
6) is the
Higher Set Point
Highest Noise Level
Z
Notes
1
-
95

Advertisement

Table of Contents
loading

Table of Contents