Deleting The Database; Lotus Notes Database Support; System Requirements - IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual

Deleting the database

The following information describes how to delete the database for all supported
operating systems.
Note: If your operating system is OS/2, refer to "Deleting the database on OS/2".
1. Start a DB2 command window.
2. Type
where
databasename is the name of the database as specified during the database
installation.
3. Press Enter.
Deleting the database on OS/2: 1.Insert the Netfinity Manager CD-ROM into the
database server CD-ROM drive (in this example, the CD-ROM drive is E).
2. Start an OS/2 window or full-screen session.
3. Make the CD-ROM drive the active drive.
Type and press Enter.
4. Type the following command at the OS/2 prompt:
where databasename is the name of the database as specified during NETFINDB
execution.
5. Press Enter.
To configure Netfinity Manager to discontinue export data through ODBC for use on
DB2, refer to "ODBC database support" on page 89.

Lotus Notes database support

To enable the Netfinity Manager to export system data to a Lotus Notes database, the
following must be done:
1. Install the Netfinity Manager database template on the Lotus Notes server.
2. Enable Netfinity Manager to export to the Lotus Notes server.
Instructions on installing the Lotus Notes database template and enabling the
Netfinity Manager to export to the Lotus Notes database follow.

System requirements

The minimum requirements for Netfinity Manager to export data to a Lotus Notes
database are:
• Lotus Notes
• Lotus Notes client
For information on what versions of Lotus Notes and the Lotus Notes client are
supported, see Table 17 on page 91. See the Notes Administrator's Guide for general
system requirements and supported communications protocols.
databasename
databasename
87
Netfinity Manager