Network Driver Interface Specification 2.01 (Os/2); Driver Messages - IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual

Table 2. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Network driver interface specification 2.01 (OS/2) driver
messages
Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller.
PCNTND-1 Unable to open the Protocol Manager.
PCNTND-6 Out of memory while allocating buffers.
PCNTND-7 A Protocol Manager device error occurred.
PCNTND-8 Bad status for the Protocol Manager.
PCNTND-9 Cannot find the PROTOCOL.INI entry.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.
PCNTND-11 Protocol Manager registration failed.
PCNTND-15 Device not found.
PCNTND-16 PCI scan specified, device not found.
22
Hardware Maintenance Manual: Netfinity 4500R Type 8656
Explanation: The Ethernet controller does not require a DMA setting.
Action: None necessary, message is for information only.
This section provides explanations of the error messages for the NDIS 2.01 (OS/2)
drivers, and suggested actions to resolve each problem.
Explanation: The NDIS stack is not configured correctly.
and correct your configuration.
Explanation: The driver could not allocate the requested buffers.
Check your system configuration. Edit the PROTOCOL.INI file to reduce the number of
Txbuffers and Rxbuffers specified for the driver.
Explanation: The NDIS stack is not configured correctly.
and correct your configuration.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
Explanation: The NDIS stack is not configured correctly.
and correct your configuration.
Explanation: The driver cannot find an Ethernet controller in the server.
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to
"Starting the diagnostic programs" on page 14 to run the diagnostic programs.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to
"Starting the diagnostic programs" on page 14 to run the diagnostic programs.
Action: Check
Action:
Action: Check
Action: Check
Action:
Action: