Unix Messages - IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual

Table 4. NDIS (Windows NT) driver messages for the Ethernet controller.
PermaNet Server:

UNIX messages

Table 5. UNIX LLI driver messages for the Ethernet controller.
pnt0-2 PCI search specified, PCI device not found!
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
•
•
pnt0-6 Cannot allocate memory for the adapter during an interrupt. Please check your Streams
parameters.
Explanation: On a SunSoft Solaris system, this message indicates that the system is out of Streams
memory blocks.
memory blocks. Modify the interrupt request (IRQ) settings in the Configuration/Setup Utility
program, or run the NETCONFIG program to match the hardware settings.
pnt0-7 Cannot allocate memory for the adapter during reset. Please check your Streams parameters.
Explanation: The system is out of Streams memory blocks.
CRASH utility to increase the number of Streams memory blocks.
pnt0-11 Device not found!
Explanation: The driver cannot find an Ethernet controller.
the Ethernet controller is enabled. If the Ethernet controller is enabled, run the diagnostic
programs.
pnt0-12 Device failed checksum test!
Explanation: The driver cannot find an Ethernet controller.
the Ethernet controller is enabled. If the Ethernet controller is enabled, run the diagnostic
programs.
pnt0-13 add_intr_handler failed! Interrupts already enabled.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts
with other devices in the server. Action: Modify your hardware settings.
pnt0-14 Cannot locate hardware.
Explanation: The SunSoft Solaris driver cannot find any Ethernet controller.
that the Ethernet controller is enabled. If the Ethernet controller is enabled, run the diagnostic
programs.
No more devices to open.
pnt0-15
Explanation: The SunSoft Solaris driver cannot find any more Ethernet controllers. Action:
Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters are present or replace the
Ethernet adapter that fails to respond. If the problem persists, run the diagnostic programs.
24
Hardware Maintenance Manual: Netfinity 4500R Type 8656
Switching back to Primary Adapter.
Explanation: The primary Ethernet connection is now operating correctly. Network traffic
will automatically transfer to the primary Ethernet controller.
message is for information only.
This section provides descriptions of the Ethernet error messages for the SCO UNIX
LLI driver, and suggested actions to resolve each problem.
Run the NETCONFIG program to search for another Ethernet controller
Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, run the
diagnostic programs.
Action: Use the CRASH utility to increase the number of Streams
Action: None needed,
Action:
Action: Use the
Action: Verify that
Action: Verify that
Action: Verify