User Password; Administrator Password; Setting, Changing, And Deleting A Password; Using Security Profile By Device - IBM ThinkCentre 8131 User Manual

User Password

When a User Password is set, the user is prompted to type a valid password each
time the computer is turned on. The computer cannot be used until a valid
password is typed from the keyboard.

Administrator Password

Setting an Administrator Password deters unauthorized persons from changing
configuration settings. If you are responsible for maintaining the settings of several
computers, you might want to set an Administrator Password.
After you set an Administrator Password, a password prompt is displayed each
time you try to access the Setup Utility program. If you type the wrong password,
you will see an error message. If you type the wrong password three times, you
must turn the computer off and start again.
If both the user and administrator passwords are set, you can type either
password. However, to change any configuration settings, you must use your
administrator password.

Setting, changing, and deleting a password

To set, change, or delete a password, do the following:
Note: A password can be any combination of up to 12 characters (A- Z, a-z, and
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Security.
3. Select Set Passwords. Read the information displayed on the right side of the

Using Security Profile by Device

Security Profile by Device is used to enable or disable user access to the following
devices:
IDE controller
Diskette Drive Access
Diskette Write Protect
To set Security Profile by Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Security.
3. Select Security Profile by Device.
4. Select the desired devices and settings and press Enter.
5. Return to the Setup Utility program menu and select Exit and then Save
28
User Guide
0-9).
page 27).
screen.
When this feature is set to Disable, all devices connected to the
IDE controller (such as hard disk drives or the CD-ROM drive)
are disabled and will not be displayed in the system
configuration.
When this feature is set to Disable, the diskette drive cannot be
accessed.
When this feature is set to Enable, all diskettes are treated as if
they are write-protected.
page 27).
Settings.