IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual page 88

9.
80
Hardware Maintenance Manual: Netfinity 4500R Type 8656
name of the file that is currently being copied.
Note: Click Cancel to stop the installation process.
Network communication drivers and the following Netfinity Manager services
are installed:
• Alert Manager
• Alert on LAN® Configuration (available only on systems running Windows
95 or later or Windows NT 4.0 or later)
• Capacity Management (available only on systems running Windows NT 4.0
or later)
• Cluster Manager (available only on systems running Windows NT 4.0 or
later)
• Critical File Monitor
• DMI Browser (requires DMI Service Layer)
• ECC Memory Setup (requires ECC memory)
• Event Scheduler
• File Transfer
• Power On Error Detect
• Predictive Failure Analysis® (requires PFA-enabled hard disk drive)
• Process Manager
• RAID Manager (requires RAID adapter)
• Remote Session
• Remote System Manager
• Remote Workstation Control
• Screen View
• Security Manager
• Serial Connection Control
• Service Configuration Manager
• Service Processor Manager
• Service Manager
• Software Inventory
• System Diagnostics Manager
• System Information Tool
• System Monitor
• System Partition Access (requires System Partition)
• Update Connector Manager (available only on systems running Windows NT
4.0 or later)
• System Profile
• Web Manager Configuration (installed only if the Netfinity Manager
Installation with Web Enhancement installation configuration is selected)
Note: The graphical user interface (GUI) program files for DMI Browser, ECC
Memory Setup, System Partition Access, RAID Manager, and Predictive
Failure Analysis will be installed regardless of whether the system has a
DMI Service Layer, ECC Memory, a System Partition, a RAID adapter, or a
PFA-enabled disk drive. This enables a network administrator to remotely
access these services on other systems within a network. However, the
installation program installs the base program that enables local use of the
service only if the required hardware or system configuration is present.
Configure the Network Drivers.
If the installation configuration allows for network access, enter information
regarding the communication protocols that are supported by the system. The
Network Driver Configuration window will appear.
Follow these steps to continue configuring the system:
a. Enter a System Name.