IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual page 125

Error Code/Symptom
014-XXX-000 (Failed
Parallel Port test)
015-XXX-001
(USB interface not found, board
damaged)
015-XXX-015
(Failed USB external loopback
test)
015-XXX-198
(USB device connected during
USB test)
020-XXX-000 (Failed
PCI Interface test)
020-XXX-001 (Failed
Hot-Swap Slot 1 PCI Latch test)
020-XXX-002 (Failed Hot-
Swap Slot 2 PCI Latch test)
020-XXX-003 (Failed Hot-
Swap Slot 3 PCI Latch test)
020-XXX-004 (Failed Hot-
Swap Slot 4 PCI Latch test)
(Failed
030-XXX-000
Internal SCSI interface test)
035-XXX-099
035-XXX-S99 (Failed
RAID test on PCI slot S, check
System Error Log before replacing
a FRU)
035-XXX-SNN (Check
System Error Log before replacing
a FRU, NN = SCSI ID of failing
fixed disk)
035-253-S99 (RAID
adapter initialization failure)
075-XXX-000 (Failed Power
Supply test)
089-XXX-001 (Failed
Microprocessor test)
FRU/Action
1. System Board
1. System Board
1. System Board
2. Make sure parrallel port is not disabled.
3. Re-run USB external loopback test.
1. System Board
2. Remove USB devices from USB1 and USB2.
3. Re-run USB external loopback test.
1. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1.
System Board
1. No adapters were found.
2. If adapter is installed re-check connection.
1. Adapter
2. SCSI Backplane
3. Cable
1. Fixed Disk with SCSI ID NN on RAID adapter in
PCI slot S.
1. ServeRAID Adapter in slot S is not configured
properly. Obtain the basic and extended
configuration status and refer to the ServeRAID
Hardware Maintenance Manual for more
information.
2. Cable
3. SCSI Backplane
4. Adapter
1. Power Supply
1. VRM for Microprocessor 1
2. Microprocessor 1
117
Symptom-to-FRU index