Completing The Installation; Connecting The Cables - IBM 326m - eServer - 7969 Hardware Maintenance Manual

Hardware maintenance manual
Hide thumbs Also See for 326m - eServer - 7969:
Table of Contents

Advertisement

Completing the installation

To complete the installation, complete the following steps:
1. Position the internal cables so they do not interfere with the cover installation.
2. Position the cover on top of the server and slide it forward. Press down on the
3. If you removed the bezel, position the bezel directly in front of the server and
4. If you removed the USB option tray, insert it fully into the slot below hard disk
5. Install the server in the rack. For details, see the Rack Installation Instructions
6. To attach peripheral devices and connect the power cord, continue with

Connecting the cables

This section provides basic information about attaching peripheral devices such as
a keyboard and pointing device to the server.
For detailed information about external options and how to connect them to your
server, see the documentation that comes with these options. For the location of
external ports and connectors on the server, see the User's Guide on the IBM
Eserver Documentation CD.
Attention:
Before sliding the cover forward, make sure that all the tabs on
both the front and rear of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be very difficult to remove the cover
later.
cover latch. The cover slides forward into position. Ensure that the cover
engages the tabs at the front and rear of the server.
press it into place so that the retention tabs snap into the holes on the top, right
side, and bottom of the server.
drive bay 1.
that come with the server.
Note: Depending on the options that you installed, after cabling the server, you
might need to run the Configuration/Setup Utility program to update the
server configuration. For more information, see "Updating the server
configuration" on page 54 and the User's Guide on the IBM Eserver
Documentation CD.
"Connecting the cables."
Note: If you installed a SCSI drive, check the LEDs to verify proper operation
after you reconnect the power cord.
Chapter 4. Installing options
53

Advertisement

Table of Contents
loading

This manual is also suitable for:

326m

Table of Contents