Riser card
Complete the following steps to remove the riser card.
Note:
1. Turn off the server and any attached devices.
2. Disconnect power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Remove the cover (see "Removing the cover and bezel" on page 32).
5. Remove adapters (see "Installing an adapter" on page 33).
6. Pull up gently on the riser card until it detaches from the server.
To replace the riser card, reverse the preceding steps.
v Read "Installation guidelines" on page 29.
v Read the safety notices at "Safety information" on page 107.
v Read "Handling static-sensitive devices" on page 30.
Note: The illustrations in this document might differ slightly from your hardware.
System board
Riser card
Chapter 6. Service replaceable units
67