Table of Contents
Advertisement
Installing a non-hot-swap hard disk drive
Before you install a non-hot-swap hard disk drive, read the following information:
v See the documentation that comes with the drive for any cabling instructions.
v Route the cable before you install the drive. Do not block the airflow from the
Complete the following steps to install a non-hot-swap hard disk drive:
1. Read the safety information that begins on page iii and "Installation guidelines"
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. Remove the server from the rack; then, remove the server cover (see
4. Press in on the USB option tray to release it and slide the tray out until it stops;
5. Install the hard disk drive in the drive bay:
6. If you have other options to install, install them now. Otherwise, go to
fans.
Drive bay 1
on page 29.
cords; then, disconnect all external signal cables from the server.
"Removing the cover and bezel" on page 32).
then, press the retention clip at the bottom rear of the tray and remove the tray
from the server. Press on the bezel retention tabs and pull the bezel directly
away from the server.
Notes:
a. If you have only one non-hot-swap hard disk drive, install it in the right-hand
bay (bay 2) with a jumper installed in the cable-selection-enabled position of
the jumper block on the rear of the drive.
b. If you have two drives and you want the server to determine the master
drive and subordinate drive automatically, install jumpers in the
cable-selection-enabled position of the jumper block on both drives.
c. If you want to assign master and subordinate drives manually, install a
jumper in the master position for the drive in bay 2 and install a jumper in
the subordinate position for the drive in bay 1.
a. Attach the rails to the sides of the drive using 2 screws for each rail.
b. Slide the drive into the bay until the rail latches snap into place.
c. Connect the signal and power cables to the rear of the drive. Keep the
cables clear of the airflow path of the fan behind the drive bays.
"Completing the installation" on page 53.
Drive bay 2
Chapter 4. Installing options
41
Advertisement
Table of Contents
