Table of Contents
Advertisement
Note: See "System" on page 100 to determine which components should be replaced by a field service technician.
Error code/symptom
175
(Hardware error)
184
(Power-on password damaged)
187
(VPD serial number not set.)
188
(Bad EEPROM CRC #2)
189
(An attempt was made to access the
server with invalid passwords)
201
(Memory test error.) If the server does not
have the latest level of BIOS installed,
update the BIOS to the latest level and run
the diagnostic program again.
289
(DIMM disabled by POST or user)
301
(Keyboard or keyboard controller error)
303
(Keyboard controller error)
602
(Invalid diskette boot record)
662
(Diskette drive configuration error)
962
(Parallel port error)
1162
(Serial port configuration conflicts)
FRU/action
v System board
1. Run the Configuration/Setup Utility program.
2. System board.
1. Set serial number in the Configuration/Setup Utility program.
2. System board.
1. Run the Configuration/Setup Utility program.
2. System board.
v Run the Configuration/Setup Utility program, and enter the
administrator password.
1. DIMM
2. System board
1. Run the Configuration/Setup Utility program, if the DIMM was
disabled by the user.
2. Disabled DIMM, if not disabled by user.
3. System board
1.
Keyboard
2. System board
v System board
1. Diskette
2. Diskette drive
3. Cable
4. System board
1. Run the Configuration/Setup Utility program and diagnostics.
2. Diskette drive.
3. Drive cable.
4. System board.
1. Disconnect the external cable on the parallel port.
2. Run the Configuration/Setup Utility program.
3. System board.
1. Run the Configuration/Setup Utility program and ensure that the
IRQ and I/O port assignments needed by the serial port are
available.
2. If all interrupts are being used by adapters, remove an adapter or
force other adapters to share an interrupt.
Chapter 7. Symptom-to-FRU index
91
Advertisement
Table of Contents
