5. On the rear panel, squeeze the expansion-slot clip to unlock the clip; then, pull
the clip out from the server until it stops and rotate the clip as shown in the
following illustration. It remains loosely attached to the server.
Alignment tab
Power-cord
module
Attention:
Avoid touching the components and gold-edge connectors on the
adapter. Ensure that the adapter is completely and correctly seated in the slot.
Incomplete insertion might cause damage to the system board or to the
adapter.
6. Remove the expansion slot cover from the slot.
7. To gain access to PCI-X slot 1, remove the PCI riser card from its connector.
System board
Adapter
retention
bracket
Retention clip
Riser card
Expansion-
slot clip (adapter slot 1)
Expansion-
slot clip (adapter slot 2)
Chapter 4. Installing options
37