Table of Contents
Advertisement
CD-ROM drive
Complete the following steps to remove the CD-ROM drive.
Note:
10. Remove the retaining wires on the drive assembly.
11. To remove the CD-ROM drive from the media tray, pull gently on the drive and
12. To remove the interposer card, remove the screw that secures it to the media
To replace the CD-ROM drive, reverse the previous steps.
v Read "Installation guidelines" on page 29.
v Read the safety notices at "Safety information" on page 107.
v Read "Handling static-sensitive devices" on page 30.
1. Turn off the server and all attached devices.
2. Disconnect all power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Remove the server cover (see "Removing the cover and bezel" on page 32);
then, take out the air baffle.
5. Remove the four microprocessor fans, making note of their orientation for later
replacement.
6. Disconnect the CD-ROM drive power cable from the system board.
7. Disconnect the IDE cable from the CD-ROM drive.
8. Press the release cam until the media tray protrudes slightly from the front of
the server.
9. Carefully pull the drive assembly out of the chassis.
slide it out of the tray.
tray and pull the card away from the media tray.
Release cam
Interposer
card
Holes
Retainer wire
Retention tab
Chapter 6. Service replaceable units
Media tray
CD-ROM
disk drive
65
Advertisement
Table of Contents
