Table of Contents
Advertisement
3. Follow the instructions on the window.
4. Select settings to view or change.
For more information on using the Configuration/Setup Utility program, see the IBM
326m User's Guide on the IBM Eserver Documentation CD.
Using the RAID configuration programs
Use the LSI Logic Configuration Utility program and ServeRAID Manager to
configure and manage redundant array of independent disks (RAID) arrays. Be sure
to use these programs as described in this book.
v Use the LSI Logic Configuration Utility program to:
v Use ServeRAID Manager to:
Detailed information about these programs is available in the User's Guide that
comes with this server.
Configuring the Gigabit Ethernet controllers
The two Ethernet controllers are integrated on the system board. They provide an
interface for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provide
full-duplex (FDX) capability, which enables simultaneous transmission and reception
of data on the network. If the Ethernet ports in the server support auto-negotiation,
the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or
1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and
automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you must
install a device driver to enable the operating system to address the controllers. For
device drivers and information about configuring the Ethernet controllers, see the
Broadcom NetXtreme Gigabit Ethernet Software CD that comes with the server. To
find updated information about configuring the controllers, complete the following
steps.
Note: Changes are made periodically to the IBM Web site. The actual procedure
1. Go to http://www.ibm.com/support/.
2. Under Search technical support, type 7969, and click Search.
3. In the Additional search terms field, type ethernet, and click Go.
Note: To use the Wake on LAN features that appear on the configuration menu,
The Ethernet controllers support optional modes, such as teaming, priority packets,
load balancing, fault tolerance, and virtual LANs, which provide higher performance,
12
326m Type 7969: Hardware Maintenance Manual and Troubleshooting Guide
– Perform a low-level format on a SCSI hard disk drive
– View or change SCSI IDs for attached devices
– Set SCSI protocol parameters on SCSI hard disk drives
– Configure arrays
– View your RAID configuration and associated devices
– Monitor operation of your RAID controllers
might vary slightly from what is described in this document.
your server must contain Wake on LAN hardware and software and your
operating system must support Wake on LAN functions.
Advertisement
Table of Contents
