Configuring A System Name; Configuring Dhcp - Cisco CVPN3002-K9 - Fast Ethernet VPN Gateway Getting Started

Configuring the Public Interface

Configuring a System Name

To assign a system name to the VPN 3002, at the prompt, enter
Step 1
At the cursor, enter a name such as VPN01. This name must uniquely identify this device on your
Step 2
network. Press Enter. The system redisplays the table of current IP addresses and the current menu
options.

Configuring DHCP

VPN 3002 Hardware Client Getting Started
4-8
This table shows current IP addresses.
Intf Status
-------------------------------------------------------------------------------
Pri Intf| UP
Pub Intf| Disabled
-------------------------------------------------------------------------------
DNS Server(s): DNS Server Not Configured
DNS Domain Name: ispdomain.com
Default Gateway: 130.0.0.1
1) Configure System Name (hostname)
2) Obtain address via DHCP for the Public Interface
3) Use PPPoE to Connect to a Public Network
4) Configure the Public Interface
5) Back
Quick ->
The system displays the System Name field.
-- : Assign a System Name (hostname) to this device.
-- : This may be required for DHCP.
> System Name
Quick -> _
This table shows current IP addresses.
Intf Status
-------------------------------------------------------------------------------
Pri Intf| UP
Pub Intf| Disabled
-------------------------------------------------------------------------------
DNS Server(s): DNS Server Not Configured
DNS Domain Name: ispdomain.com
Default Gateway: 130.0.0.1
1) Configure System Name (hostname)
2) Obtain address via DHCP for the Public Interface
3) Use PPPoE to Connect to a Public Network
4) Configure the Public Interface
Chapter 4 Using the Command-Line Interface for Quick Configuration
IP Address/Subnet Mask
| 10.10.99.50/255.255.0.0
| 0.0.0.0/0.0.0.0
IP Address/Subnet Mask
| 10.10.99.50/255.255.0.0
| 0.0.0.0/0.0.0.0
MAC Address
| 00.90.A4.00.25.A8
| 00.90.A4.00.25.A9
.
1
MAC Address
| 00.90.A4.00.25.A8
| 00.90.A4.00.25.A9
OL-2854-01