Uploading Configuration; Configuring The Private Interface - Cisco CVPN3002-K9 - Fast Ethernet VPN Gateway Getting Started

Uploading Configuration

The system prompts with a menu to enable DST (Daylight-Saving Time support. During DST, clocks are
Step 4
set one hour ahead of standard time. Enabling DST support means that the VPN 3002 automatically
adjusts the time zone for DST or standard time. If your system is in a time zone that uses DST, you must
enable DST support.
Uploading Configuration
To use the local console PC terminal emulation package to transfer (upload) configuration files from
your PC, or from a system accessible to your PC, to the VPN 3002 flash memory:
The system prompts you to choose whether or not to upload a configuration file.
Step 1
At the cursor, enter 1 Upload Config File to transfer a configuration file. If you do not want to use an
already existing configuration file, accept the default, 2, Do Not Upload Config File and continue to the
next section.

Configuring the Private Interface

To configure the VPN 3002 private interface, use these instructions:
For the VPN 3002 to become fully operational, you must configure the two interfaces you physically
connected to your network in the
•
•
VPN 3002 Hardware Client Getting Started
4-4
-- : +12 : Marshall Is.
> Time Zone
Quick -> [ -5 ] _
At the cursor, enter the time zone offset in the format +/- NN, or accept the default, -5
Eastern Standard Time.
1) Enable Daylight Savings Time Support
2) Disable Daylight Savings Time Support
Quick -> [ 1 ] _
At the cursor, enter 2 to disable DST support, or accept the default, 1, to enable DST support, and
continue to the next section.
1) Upload Config File
2) Do Not Upload Config File
3) Back
Quick -> [2]
The private interface is the interface to your internal LAN (private network).
The public interface is the interface to the public network.
Chapter 4 Using the Command-Line Interface for Quick Configuration
"Connecting Network Cables" section on page
for U.S.
,
2-3.
OL-2854-01