Table of Contents
Advertisement
Starting Quick Configuration
Starting Quick Configuration
To use the command-line interface (CLI) for quick configuration of the VPN 3002:
After booting the VPN 3002, start either the console or a Telnet or SSH session, and connect to the
Step 1
private interface of the VPN 3002 by entering the IP address for that interface.
The system displays initialization and boot messages such as:
At the cursor, enter the login name: admin. At the password prompt, enter the default password: admin.
Step 2
The system displays the opening message and prompts you to select an administrative task.
Step 3
At the cursor, enter 1 for Configuration.
The system prompts you to select a configuration task.
Step 4
VPN 3002 Hardware Client Getting Started
4-2
Boot-ROM Initializing...
Boot configured 16 MB of RAM.
...
Loading image ..........
Verifying image checksum ...........
Active image loaded and verified...
Starting loaded image...
Image Loader Initializing...
Decompressing & loading image ............
Verifying image checksum ...........
Active image loaded and verified...
Starting loaded image...
Starting power-up diagnostics...
pSH+ Copyright (c) Integrated Systems, Inc., 1992.
Cisco Systems, Inc./VPN 3002 Hardware Client Version 3.0(REL) Feb 02 2001 09:53:35
Features:
Initializing VPN 3002 Hardware Client ...
Initialization Complete...Waiting for Network...
Login:_
Login: admin
Password: admin
Welcome to
Cisco Systems
VPN 3002 Hardware Client
Command Line Interface
Copyright (C) 1998-2001 Cisco Systems, Inc.
1) Configuration
2) Administration
3) Monitoring
4) Save changes to Config file
5) Help Information
6) Exit
Main -> _
Chapter 4
Using the Command-Line Interface for Quick Configuration
OL-2854-01
Advertisement
Table of Contents
