Table of Contents
Advertisement
4
C H A P T E R
Using the Command-Line Interface for Quick
Configuration
This chapter tells you how to complete quick configuration of the system using the VPN 3002
command-line interface (CLI).
Quick configuration supplies the minimal parameters needed to make the VPN3002 operational.
The CLI is a menu-based configuration, administration, and monitoring system built into the VPN 3002.
You can use it from the console or in a Telnet or SSH session.
As you proceed, refer to the data you recorded in
Table 2-2 on page
2-6.
About Quick Configuration
You can go through quick configuration multiple times, and although it is easiest to configure its
parameters in sequence, you can set and revisit parameters in whatever order you choose.
Entries are case-sensitive; for example,
and
are different passwords.
admin
ADMIN
The system displays more tips and examples than appear in the dialog here.
The system shows current or default entries in brackets; for example,
.
[ 10.10.4.6 ]
After each entry, press the Enter key on the console keyboard.
Configuration entries take effect as soon as you enter them, and they constitute the active, or running,
configuration. The system automatically saves your entries when you press the Enter key.
If you make a mistake, the system displays an error message and repeats the previous prompt. You can
often enter a correct value and proceed, but in some cases you may need to restart the section to correct
an earlier error. See
Appendix A, "Troubleshooting and System Errors"
for more details.
VPN 3002 Hardware Client Getting Started
4-1
OL-2854-01
Advertisement
Table of Contents
