Configuring Svis For Catalyst Operating System Software On The Supervisor Engine - Cisco Catalyst 6500 Series Configuration Manual

Catalyst 6500 series switch and cisco 7600 series router firewall services
Hide thumbs Also See for Catalyst 6500 Series:
Table of Contents

Advertisement

Chapter 2
Configuring the Switch for the Firewall Services Module
This example shows a typical configuration with multiple SVIs:
Router(config)# vlan 55-57,70-85
Router(config-vlan)# exit
Router(config)# firewall vlan-group 50 55-57
Router(config)# firewall vlan-group 51 70-85
Router(config)# firewall module 8 vlan-group 50-51
Router(config)# firewall multiple-vlan-interfaces
Router(config)# interface vlan 55
Router(config-if)# ip address 10.1.1.1 255.255.255.0
Router(config-if)# no shut
Router(config-if)# interface vlan 56
Router(config-if)# ip address 10.1.2.1 255.255.255.0
Router(config-if)# no shut
Router(config-if)# end
Router#
To view your SVI configuration, enter the following command:
Router# show int vlan 55
Vlan55 is up, line protocol is up
Hardware is EtherSVI, address is 0008.20de.45ca (bia 0008.20de.45ca)
Internet address is 55.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
ARP type:ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:08, output hang never
Last clearing of "show interface" counters never
Input queue:0/75/0/0 (size/max/drops/flushes); Total output drops:0
Queueing strategy:fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
L2 Switched:ucast:196 pkt, 13328 bytes - mcast:4 pkt, 256 bytes
L3 in Switched:ucast:0 pkt, 0 bytes - mcast:0 pkt, 0 bytes mcast
L3 out Switched:ucast:0 pkt, 0 bytes
Configuring SVIs for Catalyst Operating System Software on the Supervisor
Engine
If you are running Catalyst operating system software on the supervisor engine, follow these steps to add
an SVI to the MSFC:
(Optional) To allow you to add more than one SVI to the FWSM. enter the following command:
Step 1
Console> (enable) set firewall multiple-vlan-interfaces enable
To disable this setting, enter the following command:
Console> (enable) set firewall multiple-vlan-interfaces disable
OL-6392-01
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
4 packets output, 256 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
Adding Switched Virtual Interfaces to the MSFC
2-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

7600 series

Table of Contents