Table of Contents
Advertisement
Chapter 2
Installing and Powering Up the VPN 3002
Configure the DHCP server to assign IP addresses for PCs located on the private network. The default
Step 4
IP address pool is 192.168.10.2–192.168.10.128. For Client mode, you do not need to modify this
parameter.
Configure the VPN 3002 public interface, using DHCP, PPPoE, or static address assignment. Note that
Step 5
the DHCP client is enabled by default on the public interface.
Configure the IPSec parameters with group and usernames and passwords and the IP address of the
Step 6
central-site VPN Concentrator, also known as the IKE peer.
Step 7
Set the VPN 3002 to use either Client or Network Extension mode. Client mode is enabled by default,
using Port Address Translation (PAT).
Step 8
If you are using DNS, configure local ISP DNS information for the VPN 3002.
Configure static routes.
Step 9
Change the admin password for security.
Step 10
You are done!
Quick Configuration Using Default Values
The easiest way to configure the VPN 3002 is to accept default values for all parameters that have default
values. The next sections on PAT mode and Network Extension mode list the information you need if
you use default values for quick configuration.
PAT Mode
For PAT mode, if you accept default values for all parameters, you need:
•
•
Network Extension Mode
For Network Extension mode, if you accept default values for all parameters, you need:
•
•
•
•
OL-2854-01
The IKE peer address, which is the public IP address of the VPN Concentrator to which this VPN
3002 connects.
Group and usernames and passwords. The group and usernames and passwords must also be
configured on the VPN Concentrator to which this VPN 3002 connects. On the central-site VPN
Concentrator, see Configuration | User Management | Groups, and Configuration | User
Management | Users.
An IP address for the VPN 3002 private interface (supplied by your network administrator).
The IKE peer address, which is the public IP address of the VPN Concentrator to which the VPN
3002 connects.
Group and usernames and passwords. The group and usernames and passwords must also be
configured on the VPN Concentrator to which this VPN 3002 connects. On the central-site VPN
Concentrator, see Configuration | User Management | Groups, and Configuration | User
Management | Users.
Disable PAT.
Beginning Quick Configuration
VPN 3002 Hardware Client Getting Started
2-5
Advertisement
Table of Contents
