Detaching A Remote Antenna; Inserting The Client Adapter Into A Computing Device; Inserting A Pc Card - Cisco Aironet Wireless LAN Client Installation And Configuration Manual

Chapter 2 Installing the Hardware

Detaching a Remote Antenna

Step 1 Remove the adapter from the PC card slot.
Grasp the end of the antenna cable lead by the connector.
Step 2
Gently pull the connector away from the adapter until it comes free.
Step 3

Inserting the Client Adapter into a Computing Device

This section provides instructions for inserting a PC card or a PCI client adapter into a computing device.
Caution These procedures and the physical connections they describe apply generally to conventional PC card
slots and PCI expansion slots. In cases of custom or nonconventional equipment, be alert to possible
differences in PC card slot and PCI expansion slot configurations.

Inserting a PC Card

Before you begin, examine the PC card. One end has a dual-row, 68-pin PC card connector. The card is
Step 1
keyed so that it can be inserted only one way into the PC card slot.
Step 2 Turn on your computer, let the operating system boot up completely, and follow the remaining steps in
this section to insert the PC card.
Do not force the PC card into your computer's PC card slot. Forcing it will damage both the card and
Caution
the slot. If the PC card does not insert easily, remove the card and reinsert it.
Hold the PC card with the Cisco logo facing up and insert it into the PC card slot, applying just enough
Step 3
pressure to make sure it is fully seated. See
OL-1744-02
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for MS-DOS
Inserting the Client Adapter into a Computing Device
Figure 2-2.
2-5