Inner Constant Velocity Joint, Pressing On; Installation Position Of Left Drive Shaft Transmission End Joint Boot - Rubber Version - Volkswagen PASSAT Repair Manual

Front Wheel Suspension, Shafts and Axle
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1
Fig. 4 Inner constant velocity joint, pressing
on
- Press on joint up to stop.
- Install circlip.
Note:
Chamfer on inner diameter of ball hub (splines) must
face the contact shoulder on the drive shaft.
Fig. 5 Installation position of left drive shaft
transmission end joint boot - rubber
version
Dimension "a" = 17 mm
Note:
Before assembling boot on drive shaft mark position,
dimension "a", with for example paint or adhesive
tape. Under no circumstances should paint surface
be damaged with a sharp tool.
Page 55 of 82
40-55
12/7/2004