Control Arm, Removing And Installing; Rubber Bonded Mounting, Removing - Volkswagen PASSAT Repair Manual

Rear axle, servicing (four wheel drive vehicles)
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.42.3
Fig. 5

Control arm, removing and installing

Before tightening bring control arm into horizontal
position (unladen state).
To remove the right-hand control arm inner bolt,
remove brake pressure regulator from axle beam.
Tightening torque -A-: 120 Nm (89 ft lb)
Fig. 6

Rubber bonded mounting, removing

A - 17 mm socket
B - Separating device 12 - 75 mm, e.g. Kukko 17/1
Page 7 of 13
42-39
12/7/2004