Volkswagen PASSAT Repair Manual page 319

Steering
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
- Drive sealing ring in far enough sot that the groove
for circlip in the housing is visible
- Install circlip
- Remove adhesive tape
- Remove assembly mandrel 3315/17
- Install hex nut for valve body and tighten, 30 Nm
(22 ft lb) with torque wrench SW 14 2
- Install locking screw
- Grease pressure piece and spring in housing in old
position
- Install lock nut together with adjusting screw
Note:
After tightening, the marking made during removal
(arrow) on the adjusting nut and lock nut must
match
If the toothed rod was replaced, before installing
the tie rods the steering gear must be readjusted
Page 49 of 99
48-49
12/7/2004