Bonded Rubber Mounting, Pressing 1St/2St Half Out Of Axle Beam - Volkswagen PASSAT Repair Manual

Rear Wheel Suspension, Shafts and Axle
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.42.1
Fig. 5 Bonded rubber mounting, pressing 1st
half out of axle beam
Note:
Before using special tool 3111 it is important to
grease spindle with Molybdenum grease.
Fig. 6 Bonded rubber mounting, pressing 2nd
half out of axle beam
Thread base plate into the pressure plate 3111/5 from
the opposite side.
Note:
Mounting must not be driven out. Otherwise the
mounting seat will be widened and a tight seating of
the new mounting cannot be assured.
Page 6 of 14
42-6
12/7/2004