6.
Remove the accessory kit from in front of the pallet ramp (see
aside for later use at the installation site.
7.
Remove the 3-3/8-inch hex head bolts, lock washers, and flat washers from the front
rail of the pallet and set aside. Remove the front rail from the pallet (see
8.
Cut the tape securing the ramp against the library.
9.
Use two of the 3-3/8-inch hex head bolts, lock washers, and flat washers previously
removed to secure the ramp to the pallet (see
24
Unpacking the library
1
1
Bolts
Figure 8 Removing the front pallet rail
Figure
Figure
9).
8). Set it
Figure
8).