C Ontrol - Dish Network SoloDVR ViP 612 User Manual

1
Press and hold the SAT mode button for three seconds, until all of the mode buttons light
up, and then let go of the SAT button.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (for example, three flashes means address 3).
Confirming Remote Control Operation
1
Make sure the remote has fresh batteries and is in SAT mode.
2
Press SYSTEM INFO on the receiver front panel to display the system information screen.
3
Press RECORD on the remote control:
• The Remote Address in the system information screen changes to match the address
preset in your remote control.
4
Press POWER on the remote control to turn on/off receiver.
Changing the Remote Control from UHF Pro to IR
Your receiver accepts both UHF and IR (Infrared) commands. The remote control only
outputs UHF Pro signals but can be changed to transmit IR commands by switching the
key at the bottom. This is also useful for programming an after-market universal learning
remote control to operate your receiver. Note that when the remote control is in IR mode,
you will need to use it from the same room to operate the receiver because IR signals do
not travel through walls or over great distances.
Remote Control Setup
Model ID ViP612 CVR-SD
Receiver CAID R0079256789-30
Smart Card ID S1907972574-12
DNASP206 Dsh689
Software Version AEE2WAND-N
Boot Strap Version 1010WAND
Billing & Programming 1-800-333-DISH(3474)
Technical Assistance 1-800-333-DISH(3474)
Internet Address dishnetwork.com
Receiver Mode Single Mode
Location ID 87940875:00000004
Remote Address IR/UHF Pro Band A
Help Done Cancel
Improving Receiver Control
63