Dish Network SoloDVR ViP 612 User Manual page 76

Controlling a Tuner or Amplifier
Use the following remote control buttons to control a tuner or amplifier. When the remote
control is set up as described on pages 66 and 71, press the AUX mode button to set the
remote to AUX mode. The AUX mode button will stay lit for two seconds to show you've
set the remote to AUX mode. Make sure to keep the remote in AUX mode to use the
following buttons.
Switching Between TV and Tuner/Amplifier Volume Control
When the remote control is setup to operate your TV, the VOLUME and MUTE buttons will
adjust your TV volume. To use the remote to adjust the volume of a remote-controllable
audio receiver or amplifier instead of adjusting the TV's volume, use the steps To Use a
Tuner or Amplifier's Volume Control, below. To switch back to control the TV's volume,
use the steps To Use the TV's Volume Control.
To Use a Tuner or Amplifier's Volume Control
Note: You must first program the tuner or amplifier into the AUX mode of the remote
control to use these steps.
1
Press and hold the AUX button until all the mode buttons are lit, then let it go.
Remote Control Setup
Operating Other Devices
71