Dish Network SoloDVR ViP 612 User Manual page 77

Chapter 10
Operating Other Devices
2
Press the POUND (#) button.
3
Press the PLUS side of the VOLUME button.
4
Press 0.
5
Press POUND (#). The AUX button flashes three times.
To confirm the VOLUME buttons are operating the tuner/amplifier's volume control, press
SAT and then try adjusting the volume. Your tuner/amplifier's volume should change
rather than your TV's volume.
To Use the TV's Volume Control
1
Press and hold the TV button until all the mode buttons are lit, then let it go.
2
Press the POUND (#) button.
3
Press the PLUS side of the VOLUME button.
4
Press 0.
5
Press POUND (#). The TV button flashes three times.
To confirm the VOLUME buttons are operating the TV's volume control, press SAT and
then try adjusting the volume. The TV's volume should change.
Programming to Control a Second Satellite Receiver
If you have a second DISH Network satellite receiver installed, you can use this remote in
AUX mode to operate your other receiver in addition to operating this receiver. When you
program the remote to operate the other receiver, the remote sends out IR and UHF (not
UHF Pro) signals to the receiver. You can program the remote to operate any other DISH
Network satellite receiver, except for following:
• DISH 322, ViP222, ViP622 DVR, ViP722 DVR, DISH Player-DVR 522, 625 and 942
• DishPlayer 7100/7200
72