Dish Network SoloDVR ViP 612 User Manual page 74

Instructions
5
Press the UP or DOWN ARROW
repeatedly until the device turns off.
6
Press POUND (#).
7
Turn the device back on and try some
other buttons to make sure they
work.
8
If necessary, repeat this procedure
until you've tried all the codes.
Checking the Device Codes
You can find out what device code you've set for each remote control mode (TV, VCR,
.
and AUX)
Instructions
1
Press and hold the appropriate mode
button until all the other mode buttons
light up, and then let go of the button.
The mode button flashes.
Remote Control Setup
Operating Other Devices
Additional Information
As you press the UP or DOWN ARROW, the
remote tries each code in the memory to see if
it can turn off your device. When the device
turns off, you have found a code that might
work.
Note: The mode button for the device will flash
rapidly eight times when you've scanned all the
codes for that device.
The mode button flashes three times if you
have entered the code correctly. This stores
the code you found.
Try some other buttons to make sure they
work. Sometimes POWER works when other
buttons don't. If using Limited Mode, try
VOLUME or MUTE.
You may need to repeat the scan to find the
best code for your device.
Additional Information
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
69