D Evices - Dish Network SoloDVR ViP 612 User Manual

Setting Up Using Device Code Tables
Set up the remote to control other devices using the device codes listed on page 112. In
the instructions below, the column on the left contains the instructions and the column on
the right provides additional information.
Instructions
1
Turn the device on.
2
Find the brand name of the device in
the tables starting on page 112.
3
Press and hold the mode button until
all the other mode buttons light up,
and then let go of the button. The
mode button flashes.
4
For AUX mode only. Press 0 for a TV,
or 1 for a VCR, or 2 for a tuner, or
amplifier.
5
Enter one of the three-digit device
codes from the table using the number
buttons.
6
If you want to program Limited Mode,
press 1. If not, skip to step 7.
7
Press POUND (#).
8
Press POWER to turn off the device. If
the device does not turn off, go to
step 10.
9
Turn the device back on and try some
other buttons to make sure they work.
If the code works for other buttons,
stop here.
Remote Control Setup
Operating Other Devices
Additional Information
Use the device's front panel buttons or its
remote control.
If the brand isn't listed, see Setting Up Using
Device Codes Scan on page 68.
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
If you're not programming in AUX mode, skip
to step 5.
The three-digit device code should be for the
brand name of your device that you found in
step 2.
See Limited Mode for more information.
If you entered the code correctly, the mode
button flashes three times.
If the code works, the device should turn off.
Sometimes POWER works when other
buttons don't. If in Limited Mode, try VOLUME
or MUTE.
67