Configuring A Pki (Nsm Procedure); Configuring Auto Re-Enrollment (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Table 244: VPN Monitor Options Configuration Details (continued)
Option Function
Threshold Specifies the number of consecutive failures to
determine connectivity.
Related
Documentation

Configuring a PKI (NSM Procedure)

Configuring Auto Re-enrollment (NSM Procedure)

414
Configuring IKE (NSM Procedure) on page 401
Configuring the Forwarding Options (NSM Procedure) on page 400
Configuring a Flow (NSM Procedure) on page 393
The Public Key Infrastructure (PKI) feature allows you to configure automatic
re-enrollment, Certificate Authority (CA) certificate, CA profile, certificate revocation list
(CRL), local certificate, and traceoptions.
To configure the PKI feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the PKI feature.
Click the Configuration tab. In the configuration tree, select Security > Pki.
3.
Select the Enable Feature check box to enable this feature.
4.
Enter a comment in the Pki workspace that describes the PKI.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the PKI parameters.
You can now configure the following options:
Configuring Auto Re-enrollment (NSM Procedure) on page 414
Configuring a CA Profile (NSM Procedure) on page 415
Configuring Traceoptions (NSM Procedure) on page 417
To configure the auto re-enrollment feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the auto re-enrollment feature.
Your Action
Set the threshold to determine connectivity.
Range: 1 - 65536.
Copyright © 2010, Juniper Networks, Inc.