Configuring A Bridge (Nsm Procedure); Table 226: Flow Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 226: Flow Configuration Details

Option
Comment
Allow Dns Reply
Route Change Timeout
Syn Flood Protection Mode

Configuring a Bridge (NSM Procedure)

394
Click the Configuration tab. In the configuration tree, select Security > Flow.
3.
Configure the options as specified in Table 226 on page 394.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the flow parameters.
Function
Supplies a descriptive comment for the flow
feature.
Allows unmatched incoming DNS reply packets.
Specifies the timeout value for route change to
nonexistence route.
Specifies the TCP synchronized flood-protection
mode.
You can configure the following options:
Configuring a Bridge (NSM Procedure) on page 394
Configuring the TCP MSS Option (NSM Procedure) on page 395
Configuring the TCP Session Option (NSM Procedure) on page 396
Configuring Traceoptions (NSM Procedure) on page 397
To configure a bridge option:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure a bridge option.
Click the Configuration tab. In the configuration tree, select Security > Flow > Bridge.
3.
Configure the options as specified in Table 227 on page 395.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the bridge settings.
Your Action
(Optional) Enter a comment.
Select the Allow Dns reply check box to enable
this feature.
Set the timeout value for the route change.
Range: 6 - 1800.
Select the synchronized flood protection mode
from the list.
Copyright © 2010, Juniper Networks, Inc.