Configuring Protocol Family (Mpls) Information For The Logical Interface (Nsm; (Nsm Procedure); Table 118: Iso Family Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
232

Table 118: Iso Family Configuration Details

Task
Configure Iso information.
Configure the interface
address.

Configuring Protocol Family (MPLS) Information for the Logical Interface (NSM

Procedure)
To configure mpls family information in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
Add or modify settings as specified in Table 119 on page 233.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Family next to Unit.
6. Expand Family.
7. Click Iso next to Family.
8. In the Comment box, enter the comment.
9. From the Mtu list, select the MTU size.
Range: 0 through 4294967295
1. Click Address next to Inet.
2. Click Add new entry next to Address.
3. Expand address.
4. In the Name box, enter the interface name.
5. In the Comment box, enter the comment.
Copyright © 2010, Juniper Networks, Inc.