Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 391

Copyright © 2010, Juniper Networks, Inc.
Table 200: RSVP Configuration Details (continued)
Task
Configure administrative
groups for bypass LSPs.
Configuring the bandwidth
for bypass LSPs.
Configure a bypass LSP
Your Action
1. Click Admin Group next to Link Protection.
2. Click Exclude next to Admin Group.
3. Click Add new entry next to Exclude.
4. In the New exclude window, enter the administrative groups
to exclude for a bypass LSP.
5. Click Include All next to Admin Group.
6. Click Add new entry next to Include All.
7. In the New include-all window, enter the administrative groups
whose links the bypass LSP must traverse.
8. Click Include Any next to Admin Group.
9. Click Add new entry next to Include Any.
10. In the New include-any window, enter the administrative
groups whose links the bypass LSP can traverse.
1. Click Bandwidth next to Link Protection.
2. In the Per Traffic Class Bandwidth box, enter the bandwidth.
3. In the class-type number box, enter the class-type bandwidth.
1. Click Bypass next to Link Protection.
2. Click Add new entry next to Bypass.
3. Click Admin Group next to Bypass.
4. Click Exclude next to Admin Group.
5. Click Add new entry next to Exclude.
6. In the New exclude window, enter the administrative groups
to exclude for a bypass LSP.
7. Click Include All next to Admin Group.
8. Click Add new entry next to Include All.
9. In the New include-all window, enter the administrative groups
whose links the bypass LSP must traverse.
10. Click Include Any next to Admin Group.
11. Click Add new entry next to Include Any.
12. In the New include-any window, enter the administrative
groups whose links the bypass LSP can traverse.
13. Click Bandwidth next to Link Protection.
14. In the Per Traffic Class Bandwidth box, enter the bandwidth.
15. In the class-type number box, enter the class-type bandwidth.
16. Click Path next to Bypass.
17. Click Add new entry next to Path.
18. In the Name box, enter the IP address of each transit router in
the LSP.
19. Select one of the following:
loose—If the LSP can traverse other routers before reaching
this router.
strict—If the LSP must go to the next address specified in
the path statement without traversing other nodes.
Chapter 20: Configuring Protocols
355