Configuring Traceoptions (Nsm Procedure); Table 326: Infranet Controller Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 326: Infranet Controller Configuration Details

Option Function
Name Specifies the name of the infranet controller.
Comment Specifies the comment for the infranet controller.
Address Specifies the infranet controller IP address.
Port Specifies the infranet controller port.
Interface Specifies the outgoing interface.
Password Specifies the infranet controller server password.
Server Certificate Specifies the subject name of the infranet controller
Subject certificate to match.
infranet-controller > Ca Profile
Ca Profile Specifies the certification authority profile.

Configuring Traceoptions (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
To configure infranet controller options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure infranet controller options.
Click the Configuration tab. In the configuration tree, select Services > Unified Access
3.
Control > Infranet Controller.
Add or modify the settings as specified in Table 326 on page 523.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the infranet controller options.
This section describes how to configure traceoptions for UAC.
To configure traceoptions:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the traceoptions feature.
Chapter 23: Configuring Services
Your Action
Enter a name.
Enter a comment.
Enter the IP address.
Enter the port number. Range: 1 through
65535.
Enter an interface.
Enter the password.
Enter the server certificate subject.
Select the required profile from the
Non-members list and click Add to move the
profiles to the Members list.
523