Known Problems And Limitations; Ancp; Atm - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - RELEASE NOTES 2010-11-09 Release Note

JunosE 11.3.0 Release Notes

Known Problems and Limitations

ANCP

ATM

40

Known Problems and Limitations

This section identifies the known problems and limitations in this release. For more
information about known problems that were discovered at customer sites, you can log
in to the JunosE Knowledge Base at https://www2.juniper.net/kb/, enter the defect ID
number in the Search by Keyword field, and click Search.
On an E320 router that has established 3000 ANCP adjacencies with a client and

traffic is initiated, the following behavior occurs sporadically: All existing Telnet
sessions are disconnected and no new Telnet sessions can be established for several
minutes. [Defect ID 83872]
The line module resets when you issue the show nbma arp command after you have

configured NBMA interfaces on an ATM line module. [Defect ID 88491]
When 16,000 PPPoA interfaces are configured on an OCx/STMx ATM line module

paired with an OC3-4 I/O module in an ERX14xx model, ERX7xx model, or ERX310
router, Ping traffic passing through the line module on the restarting router
experiences an outage of 103 seconds, which is beyond the maximum limit, after a
unified ISSU from JunosE Release 9.2.0p1-0 to 9.3.0b0-12. This outage does not
occur when the same configuration is applied on a Gigabit Ethernet interface. [Defect
ID 179794]
The inPacketOctetDiscards counter in the output of the show atm vc atm interface

vcd command includes both inBytesDropped and inBytesUnknownProtocol
statistics. The inBytesUnknownProtocol statistics should be displayed by a separate
counter.
At the major interface level, the inPacketDiscards counter includes both
inPacketsDropped and inPacketUnknownProtocol statistics. The
inPacketUnknownProtocol statistics should be displayed by a separate counter.
[Defect ID 44286]
When a mirror rule that triggers on username is employed for packet mirroring of

dynamic IP subscribers over ATM, removal of the rule does not disable packet
mirroring. [Defect ID 175356]
Work-around: Use a mirror rule that triggers on account session ID rather than on
username.
When you issue the no atm atm1483 auto-configure upperInterfaceType

lockout-time command in Profile Configuration mode, the lockout time range does
not revert to the default values. [Defect ID 66544]
When one or more ATM1483 attributes appears in a profile, the show configuration

include-defaults command fails to display the default values for all possible
ATM1483 attributes. [Defect ID 67157]
The output of the show atm arp command displays only 4096 entries when the line

module is configured with more than 4096 NBMA ARP entries. [Defect ID 68849]
The baseline interface atm command fails for a VCD assigned by the router to F4

OAM circuits. [Defect ID 174482]
Copyright © 2010, Juniper Networks, Inc.