Table of Contents
Advertisement
Unified ISSU
Unsupported Features
The JunosE Release 10.3.x documentation set describes some features that are
present in the code but that have not yet been fully qualified by Juniper Networks. If
you use any of these features before they have been fully qualified, it is your
responsibility to ensure that the feature operates correctly in your targeted
configuration.
The following features are present but unsupported in this release.
E120 Router and E320 Router
Multicast
Policy Management
Service Manager Support for Unified ISSU
Service Manager support for unified ISSU is limited in this release to early field
trial purposes only.
The ES2 10G LM and ES2 10G Uplink LM do not support layer 2 statistics for
VLANs.
Subscriber Interfaces on the ES2 10G Uplink LM
You can configure dynamic subscriber interfaces and static subscriber
interfaces on the ES2 10G Uplink LM using the CLI. However, configuring
subscriber interfaces on the ES2 10G Uplink LM provides no benefit because
access features such as per-subscriber QoS are unavailable on the module.
Unsupported IPv6 Data MDT Commands in CLI
The ipv6 pim data-mdt command and the show ipv6 pim data-mdt
command are unsupported in the current release.
The IPv6 PIM Data MDT Configuration mode is unsupported in this release. The
following commands appear in IPv6 PIM Data MDT Configuration mode but are
unsupported in the current release:
ipv6 pim join-filter
ipv6 pim query-interval
mdt-data-delay
mdt-data-holdown
External Parent Groups Unsupported on ES2 10G, ES2 10G Uplink, and ES2
10G ADV LMs
External parent groups are not supported on the ES2 10G, ES2 10G Uplink, and
ES2 10G ADV LMs. If you create a policy that references an external parent
group on these LMs, the system prevents you from attaching it to the LM
interface and you receive an error message.
mdt-data-timeout
route map
tunnel group-address-pool
tunnel source
Unsupported Features
Release 10.3.2
9
Advertisement
Table of Contents
