Monitoring The Fic Status; Understand Fic Slot Numbering; Display Fic Status At The Command Line - Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Network Operation Manual

Monitoring the FIC Status

If the FIC fails, no information about chassis components is available through the
JUNOS software command-line interface (CLI).
To monitor the FIC status, follow these steps:
Steps To Take
1. Understand FIC Slot Numbering on page 445
2. Display FIC Status at the Command Line on page 445
3. Check FIC LEDs on page 446
Step 1: Understand FIC Slot Numbering
Figure 179 shows the FIC location and numbering in the M7i router. The FIC is
located in FPC 1 slot 3.
Figure 179: FIC Numbering
FPC0
FPC1
Step 2: Display FIC Status at the Command Line
To display the FIC status, use the following CLI command:
Action
Sample Output
user@host> show chassis pic pic-slot 3 fpc-slot 1
PIC fpc slot 1 pic slot 3 information:
PIC Port Information:
Since the FIC is located in FPC 1 slot 3, you must specify its location with the show
What It Means
chassis pic
as the FIC type, ASIC type, operating status, PIC version, and the amount of time
the FIC has been online. The command output also displays port cable information.
PICs
0/3 0/2 0/1
Built-in tunnel interface
1/3 1/2
and optional ASM
FIC
user@host> show chassis pic pic-slot 3 fpc-slot 1
Type
ASIC type
State
PIC version
Uptime
Port Cable
Number Type
0 UNKNOWN CABLE
CLI command. The command output displays the FIC information, such
0/0
1x G/E, 1000 BASE
QGE FPGA
Online
1.4
12 hours, 11 minutes, 39 seconds
SFP SFP Vendor
Vendor Name Part Number
Chapter 34: Monitoring the FIC
!
445
Monitoring the FIC Status