Getting Routing Engine Hardware Information; Display Routing Engine Hardware Information - Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Network Operation Manual

Getting Routing Engine Hardware Information

To get hardware information for a failed Routing Engine, follow these steps:
Steps To Take
1. Display Routing Engine Hardware Information on page 157
2. Locate the Routing Engine Serial Number ID Label on page 158
Step 1: Display Routing Engine Hardware Information
To display the Routing Engine hardware information, use the following CLI
Action
command:
For an M20 router with two Routing Engines:
Sample Output
user@host> show chassis hardware
Hardware inventory:
Item
Chassis
Backplane
Power Supply A
Power Supply B
Display
Routing Engine 0
Routing Engine 1 REV 01
[...Output truncated...]
For M40 router components:
user@host> show chassis hardware
Hardware inventory:
Item
Backplane
Power supply A
Maxicab
Minicab
[...Output truncated...]
The sample output for an M20 router displays the Routing Engine, slot number, and
What It Means
serial number, and indicates that it is present in the router. Give this information to
JTAC if the Routing Engine fails.
The sample output for an M40 router shows that the maxicab is the (Motorola)
Routing Engine, and the minicab is the Routing Engine and Packet Forwarding
Engine interface.
On other routers, the Routing Engine serial number is located in the host hardware
inventory line.
user@host> show chassis hardware
Version Part number
REV 03 710-001517
Rev 01 740-001465
Rev 01 740-001465
REV 04 710-001519
740-003239
Version Part number
REV 02 710-000073
Rev 2 740-000235
REV X1 710-000229
REV X1 710-000482
Chapter 14: Monitoring the Routing Engine
Serial number Description
AA7915
000011 AC
000016 AC
AE6019
32000004f8ff1201 RE-2.0
AARCHOO RE-2.0
Serial number Description
S/N AA0053
S/N 000042 DC
S/N AAO139
S/N AA0201

Getting Routing Engine Hardware Information

!
157