Chapter 38 Monitoring Redundant Power Supplies - Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Network Operation Manual

Chapter 38
Monitoring Redundant Power Supplies
Table 111: Checklist for Monitoring Redundant Power Supplies
Monitor Redundant Power Supply Tasks
Understanding Redundant Power Supplies on page 508
!
M5/M10 Router Redundant Power Supplies on page 508
!
M7i Router Redundant Power Supplies on page 509
!
M10i Router Redundant Power Supplies on page 510
!
M20 Router Redundant Power Supplies on page 511
!
M40 Router Redundant Power Supplies on page 512
!
M40e Router Power Supplies nand Location on page 513
!
M160 Router Redundant Power Supplies on page 515
!
M320 Router Redundant Power Supplies on page 516
!
T320 Router Redundant Power Supplies on page 517
!
T640 Routing Node Redundant Power Supplies on page 518
Displaying Redundant Power Supplies Installed In The
Router on page 519
Checking the Redundant Power Supply Status on
page 521
Checking for Power Supply Alarms on page 521
Verifying Power Supply Failure on page 521
Getting Power Hardware Information on page 521
Replacing a Power Supply on page 521
See Also
You monitor and maintain redundant power supplies to ensure that power is
distributed to the router components without interruption. (See Table 111.)
Monitoring Power Supplies on page 217
!
Command or Action
show chassis hardware
For more information about monitoring power supplies, see
"Checking the Power Supply Status" on page 230.
For more information about checking for power supply
alarms, see "Checking for Power Supply Alarms" on page 235.
For more information about removing a power supply, see
"Replacing the Power Supplies" on page 250.
!
507