Table of Contents
Advertisement
Performing a Swap Test on a SIB
SIBs are hot-insertable and hot-removable.
To perform a swap test on a SIB, see "Verifying SIB Failure" on page 334.
Action
Returning the SIB
To return a SIB, locate the serial number label on the left side of the SIB top panel,
Action
then follow the procedure "Return the Failed Component" on page 86. You can also
refer to the procedure to return a field-replaceable unit in the M320 router, T320
router, or the T640 routing node hardware guide.
Chapter 40: Monitoring Redundant SIBs
Performing a Swap Test on a SIB
!
549
Advertisement
Chapters
Table of Contents
Related Manuals for Juniper JUNOS - NETWORK OPERATION GUIDE REV1
Related Products for Juniper JUNOS - NETWORK OPERATION GUIDE REV1
- Juniper NETWORKS STRM - TECHNICAL NOTE REV 6-2008
- Juniper JUNOSE 11.1.0 - REV 4-29-2010
- Juniper MEDIA FLOW CONTROLLER 2.0.5 - S REV 15-11-2010
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - REV1
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 MODULE GUIDE REV 01-10-2010
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 HARDWARE GUIDE REV 9-29-2010
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX MODULE GUIDE REV 27-9-2010
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010
Need help?
Do you have a question about the JUNOS - NETWORK OPERATION GUIDE REV1 and is the answer not in the manual?