Viewing Craft Interface Information From The Command Line - Juniper JUNOS - NETWORK OPERATION GUIDE REV1 Network Operation Manual

JUNOS Internet Software Network Operations Guide: Hardware
What It Means
Alternative Action

Viewing Craft Interface Information from the Command Line

Action
!
204

Viewing Craft Interface Information from the Command Line

For M5, M10, M20, and M40 routers, the command output displays the craft
interface state, which can be OK or Absent .
For M40e and M160 routers, the command output displays the FPM Chassis
Management Bus (CMB) status and the FPM display status, which can be OK or
Absent .
For M320 routers, the command output displays the FPM CMB status only.
For T320 routers and T640 routing nodes, the command output displays the FPM
circuitry and the FPM display status, which can be OK or Absent .
(For M40e, M160, M320, and T320 routers and the T640 routing node) To monitor
the craft interface environmental status, use the following CLI command:
user@host> show chassis environment fpm
user@host> show chassis environment fpm
FPM status:
State
FPM CMB Voltage:
5.0 V bias
8.0 V bias
FPM Display Voltage:
5.0 V bias
FPM CMB temperature
FPM Display temperature
CMB Revision
The command output displays the status of the FPM or craft interface, which can be
or Offline . It also displays information about the power supplied to the FPM
Online
CMB or FPM GBUS, information about the FPM display power supply, the
temperature of the air flowing past the FPM CMB or FPM GBUS and the FPM
display, and the CMB or GBUS revision level.
If the craft interface fails, you can still display the craft interface information from
the CLI. The values reflect what would be visible if the craft interface were operating
normally.
To display craft interface information, use the following CLI command:
user@host> show chassis craft-interface
Online
5030 mV
8083 mV
4998 mV
34 degrees C / 93 degrees F
35 degrees C / 95 degrees F
12